Truma iNET & iNET X Panel (Gas) - Error codes & Troubleshootings

Models where it applies: Nomad / Nomad PopTop / Grand California / Solis / Solis Air

Truma CP plus VarioHeat Operating ...Screens-Panel-Dashboard.2022-05-20-12-34-34.png

 

Related articles:

________________________________________________________________________________________________________________

TRUMA CP PLUS GAS MODEL error codes:

Error code Cause Rectification
W 17 H Hot water mode with empty water container. Switch off Combi and allow to cool. Fill water container with water.
W 18 H Warm-air outlet blocked. Check the individual outlet openings.
E 18 H Circulated air intake blocked. Contact Customer Support
E 21 H Room temperature sensor/cable defective. Contact Customer Support
W 24 H Imminent undervoltage, battery voltage too low < 10.4V. Charge battery 🎥.
E 41 H Electronics blocked. Contact Customer Support
E 43 H Excess voltage > 16.4 V Check battery voltage and power sources, such as battery charger 🎥.
E 44 H Undervoltage, battery voltage too low < 10.0V. Charge battery. If necessary, replace old battery 🎥.

E 112 H
E 202 H
E 121 H
E 211 H

Gas cylinder closed. Check gas supply.
Gas shut-off valve is closed – switch position = off. Open gas shut-off valve – switch position = on.
Overheating protection has responded. Switch off Combi and allow to cool; if necessary, fill the water container with cold water. Check warm air outlets and circulated air intake and remove blockages. Switch Combi on again.
E 122 H
E 212 H
Combustion air infeed or exhaust gas outlet closed. Check for obstructions such as slush, ice or leaves and remove from the openings.
Gas shut-off valve is closed – switch position = off. Open gas shut-off valve – switch position = on.
Gas pressure regulation system defective. Contact Customer Support.
Overheating protection has responded. Switch off Combi and allow to cool; if necessary, fill the water container with cold water. Check warm air outlets and circulated air intake and remove blockages. Switch Combi on again.
Electronics defective. Contact Customer Support.
W 255 H Combi has no 12V DC power supply. Ensure 12V DC power supply 🎥.
No connection between the Combi and control panel. Ensure connection between Combi and control panel.
Control panel cable defective. Contact Customer Support.

 

 

 

 

Was this article helpful?
Go back

Need more help?

Our team is here for you, wherever your road trip takes you

WhatsApp

Instant

Email

< 24 hours